Revision:1.0(2023-01-12)
173
the first-level directory, and 01 indicates that "Parameter board I2C communication test" is the
first test item under "Main display".
55..22..55..33 User Self-Test
Turn on the machine, tap Setup, and choose Maintenance>Setup>Self-test for a self-test.
Figure5–8 User self-test page
The user self-test page is divided into three areas: self-test item display area, monitoring
information bar, and status bar. The functions of the monitoring information bar and status bar are
the same with those on the user page. The self-test item display area shows only tested items, but
not the test results.
Button or Check Box
Description
Start/Stop Click this button to test the selected test items one by one, and
meanwhile the button will change to the Stop button. If the Stop button
is clicked during the test, the test will be terminated. After the test is
completed, the text on the Stop button will become Start again, and
can be clicked to start the next test.
Test Report Save
Path check box
This check box displays the logical drive letter of the mobile storage
medium connected to this system (such as the USB flash drive and
mobile hard disk). During the test, this check box is unavailable.
If there is no mobile storage medium, click the control and the system
will prompt you to insert the mobile storage medium.
Diagnostic Ultrasound System
Service Manual
5 Maintenance
To Next Page
Loading...
Need help?
General
