Chapter 13 Changing Settings
176
Changing
Settings
(2) Acquiring an IP address from the DHCP server
Configure the following setting to acquire an IP address from the DHCP server on the network.
1 Display the [SETUP MENU: NETWORK] screen.
2 Enable or disable the [DHCP] checkbox in the
[INTERNAL SERVER] area.
Select (enable) the [DHCP] checkbox to acquire an IP
address from the DHCP server.
• Enable/Disable (Initial setting: Disable)
When the [DHCP] checkbox is selected, the characters in
the [IP ADDRESS] field and [SUBNET MASK] field change
to red, disabling entry.
Immediately after enabling the [DHCP], “--- --- --- ---” is
shown in the [IP ADDRESS] and [SUBNET MASK] fields.
Turn off the DS-L3, then turn it on, and values are indicated
in the fields after the IP address is notified from the DHCP
server.
3 Press the [SAVE] button.
The above setting is saved.
Acquiring an IP address from the DHCP Server
[DHCP] Checkbox Setting
Choice Setting
Enable Acquires an IP address from the DHCP server on the network.
Disable Manually enter an IP address and a subnet mask required for network connection. (Default)
Changing IP address
Turn off and on the DS-L3 after you changed the IP address acquiring method.
Using DHCP server
To use the DHCP server, it must exist on your network. If you use the DS-L3 in an environment that contains no DHCP
server, clear (disable) the [DHCP] checkbox and use the DS-L3 with a fixed IP address.
Network connection
When the [DHCP] checkbox is selected, the DS-L3 acquires an IP address automatically from the DHCP server on
the network during startup.
2
1
3
Switch IP address
acquiring method.
The color of values turns red,
disabling modification.
To Next Page
Loading...
Need help?
General
