Chapter 16 Connecting to Network
234
Connecting to
PC, Printer, and
Network
16.6
Operating from the PC with the Telnet Command
You can operate the DS-L3 by executing the Telnet command from the PC.
Executing Telnet command
Before executing the Telnet command, be sure to consult the network administrator of your organization. Since unique
settings may be made in some organizations, executing the Telnet command may cause a network error.
1 Open Windows [Command Prompt] and enter the IP address of DS-L3 to make a connection.
For an example of DS-L3 IP address of “192.168.10.2”:
• Example: Telnet 192.168.10.2
2 Execute the Telnet command.
For executable Telnet commands, see the Telnet command list.
Telnet command list
A detailed command list is available. If you need it, contact your nearest Nikon representative.
To Next Page
Loading...
Need help?
General
