2-16SectionSpecial Functions
255
Alarm History
Occurrence order
No. Comment YY/MM/DD HH:MM 1/1
1 WATER TANK OVERHEATING 98/02/22 13:05
2 PROCESS 3 STOPPED 98/02/22 13:06
3 PROCESS 3 STOPPED 98/02/22 13:08
4 SUPPLY MATERIAL A 98/02/22 13:09
5 WATER TANK OVERHEATING 98/02/22 13:10
6 WATER TANK TEMP. TOO LOW 98/02/22 13:12
7 WATER TANK OVERHEATING 98/02/22 13:15
8 PROCESS 5 EMERGENCY STOP 98/02/22 13:20
9 TEMP. OUT OF SETTING RANGE 98/02/22 13:21
10 SUPPLY LABEL PAPER 98/02/22 15:42
11 SUPPLY MATERIAL A 98/02/22 15:42
12 TEMP. OUT OF SETTING RANGE 98/02/22 15:45
13 WATER TANK TEMP. TOO LOW 98/02/22 15:49
14 SUPPLY MATERIAL A 98/02/22 15:52
15 TEMP. OUT OF SETTING RANGE 98/02/22 15:57
Frequency order
No. Comment Cnt. 1/1
1 WATER TANK OVERHEATING 15
2 WATER TANK TEMP. TOO LOW 14
3 PROCESS 3 STOPPED 10
4 TEMP. OUT OF SETTING RANGE 8
5 SUPPLY MATERIAL A 7
6 PROCESS 5 EMERGENCY STOP 7
7 SUPPLY LABEL PAPER 6
8 SUPPLY MATERIAL B 5
9 PROCESS 2 STOPPED 1
10 PROCESS 1 STOPPED 1
2-16-8 Adjusting Contrast and Brightness During PT Operation
With the NT31/31C and NT631/631C, in addition to using the System Menu
(Maintenance Mode → I/O Setting), you can also adjust the backlight brightness
and contrast while the PT is in operation.
While the PT is in operation, display screen number 9030, the brightness and
contrast adjustment screen, by specifying the screen in the PT status control
area, or by using a touch switch with a screen switching function. After displaying
the screen, make the desired settings.
The brightness and contrast adjustment screen can be displayed using either of
the following two methods.
Displaying the
Brightness and Contrast
Adjustment Screen
To Next Page
Loading...
Need help?
General
