Parker Compax3 User Manual

Setting up Compax3
C3I12T11
266
192-120113 N08 C3I12T11 - December 2010
4.4.9.7 Overview of the user interface
In this chapter you can read about:
Selection of the signal or system to be measured. ......................................................... 266
Frequency settings ........................................................................................................ 271
Speed control ................................................................................................................ 271
Other settings ................................................................................................................ 273
Operating and status field .............................................................................................. 275
Display of the measurement result ................................................................................ 277
Display of the measurement point at the cursor position ................................................ 278
(1) Selection of the signal or system to be measured (see on page 266)
(2) Frequency settings (see on page 271)
(3) Other settings (see on page 273)
(4) Operating and status field (see on page 275)
(5) Display of the measurement result (see on page 277)
(6) Display of the measurement point at the cursor position (see on page 278)
Selection of the signal or system to be measured.
In this chapter you can read about:
Current control ............................................................................................................... 267
Mechanical system ........................................................................................................ 268
Position control .............................................................................................................. 269
With the aid of the tree structure, you may select what you want to measure. Here,
the selection is made, if a frequency spectrum or a frequency response is to be
measured.
The shown structures are simplified in such as all feedbacks are displayed without
special transmission behavior. This is surely not the case in reality, serves however
a better overview.

Parker Compax3 Specifications

General

Brand	Parker
Model	Compax3
Category	Servo Drives
Language	English