Parker EME
Compax3 device description
192-120113 N08 C3I12T11 - December 2010
3.6.3. Compax3H connections front plate
Communication and signal interfaces
Showcase front plate of the control (number of connectors depends on the
extension level of the Compax3)
X20
X21
X22
X23
S24
X12 X13
X11
X3
LED3
LED2
LED1
X4
X10
X3
Motor brake
X20
HEDA in (Option)
X4
24VDC
X21
HEDA out (Option)
X10
RS232/RS485 with jumper to the
programming interface
X22
Inputs Outputs (Option M10/12)
X11
Analog/Encoder
X23
Bus (Option)
Connector type
depends on the bus
system!
X12
Inputs/Outputs
S24
Bus settings
X13
Motor position feedback
LED1
Device status LEDs
LED2
HEDA LEDs
LED3
Bus LEDs
The internal device status LEDs are only connected to the external housing LEDs,
if the RS232 jumper at X10 is fitted to the control and the upper dummy cover is
fitted.
The RS232 programming interface under the upper dummy cover is only available
if the X10 jumper at the controller is fitted.
3.6.4. Plug and pin assignment C3H
AC - Versorgung
AC - Supply
DC - Versorgung
DC - Supply
X4 (24VDC)
RS232
SSK1
PC
Compax3
Further information on the assignment of the plug mounted at the particular
device can be found below!
To Next Page
Loading...
Need help?
General
