Polaris 2014 RZR XP 1000 Service Manual

4.34
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
1. With the throttle pedal “at rest”, connect an
ohmmeter between the TRS pin terminals. A
resistance value of 2.15k Ohms +/- 5% at room
temperature should be obtained. If the sensor reading
is more than 2.26k Ohms, it is out of specification
and needs to be replaced.
2. With the throttle pedal fully depressed, connect an
ohmmeter between the TRS pin terminals. A
resistance value of 6.8k Ohms +/- 5% at room
temperature should be obtained. If the sensor reading
is less than 6.46k Ohms, it is out of specification and
needs to be replaced.
THROTTLE “AT REST”
THROTTLE FULLY
DEPRESSED
2.15 k Ohms +/-5% 6.8 k Ohms +/-5%
Replace sensor if
reading is more than:
2.26 k Ohms
Replace sensor if
reading is less than:
6.46 k Ohms
The Pedal Position Sensor is calibrated to the throttle
pedal. If the PPS is faulty, the throttle pedal assembly
must be replaced (see "PPS Replacement").
PPS Replacement
NOTE: The PPS is calibrated to the throttle pedal. If
the PPS is faulty, the throttle pedal assembly must
be replaced.
1. Disconnect the PPS harness connection (Item 2)
located on the throttle pedal.
2. Remove the drivers seat and disconnect the
negative (-) battery cable.
3. Remove the three bolts (Item 3) securing the throttle
pedal assembly to the frame support.
4. Remove the pedal assembly from the vehicle.
ETC Installation
5. Place the throttle pedal assembly on the mounting
studs and loosely install the three fasteners.
6. Torque the three mounting bolts to specification and
connect the PPS harness connection.
Throttle Pedal Mounting fasteners:
18 ft-lb (24 Nm)
7. Manually cycle the throttle pedal to verify the throttle
pedal moves freely.
8. Connect the negative (-) battery cable and install the
drivers seat.
ELECTRONIC FUEL INJECTION

Polaris 2014 RZR XP 1000 Specifications

General

Brand	Polaris
Model	2014 RZR XP 1000
Category	Utility Vehicle
Language	English