To Next Page

To Previous Page

2.10

9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual

GENERAL VEHICLE INSPECTION AND MAINTENANCE

Pre-Ride / Daily Inspection

Perform the following pre-ride inspection daily, and when

servicing the vehicle at each scheduled maintenance.

• Engine Oil - Check for proper level on dipstick

(refer to “Engine Oil Level” procedure)

• Tires - check condition and pressures

• Fuel tank - fill to proper level

• All brakes - check operation and fluid level and

adjustment (includes parking brake on INT’L

Model)

• Headlights/Taillights/Brakelights - also check

operation of all indicator lights, instrument cluster

and switches

• Ignition switch - check for proper function

• Wheels - check for tightness of wheel nuts and

axle nuts; check to be sure axle nuts are secured

by cotter pins

• Engine Intake Pre-Filter - Inspect pre-filter and

clean with soapy water and low pressure

compressed air if necessary

• PVT Intake Pre-Filter - Inspect pre-filter and clean

with soapy water and low pressure compressed air

if necessary

• Steering - check for free operation noting any

unusual looseness in any area

• Loose parts - visually inspect vehicle for any

damaged or loose nuts, bolts or fasteners

• Engine coolant - check for proper level at the

recovery bottle

• Drive Shaft Boots - Inspect inner and outer boots

for tears or damage on both front and rear drive

shafts

• Check all front and rear suspension components

for wear or damage.

Shift Cable Inspection / Adjustment

Shift cable adjustment may be necessary if symptoms

include:

• No gear position or AWD display on instrument

cluster

• Ratcheting noise on deceleration

• Inability to engage into a gear

• Excessive gear lash (noise)

• Gear selector moving out of desired range

1. Locate the shift cable (Item 1) attached to the

transmission case in the right rear wheel well area.

2. Inspect shift cable, clevis pin, pivot bushings (Item

4), and dust boot (Item 3). Replace if worn or

damaged.

3. If adjustment is required, loosen the lower jam nut

(Item 6) and pull the cable out of the mount (Item 2)

to move the upper jam nut (Item 5).

4. Adjust the shift cable so there is the same amount of

cable travel when shifting slightly past HIGH gear

and PARK.

MAINTENANCE

Brand	Polaris
Model	2014 RZR XP 1000
Category	Utility Vehicle
Language	English

Polaris 2014 RZR XP 1000 Service Manual

Table of Contents

Questions and Answers:

Polaris 2014 RZR XP 1000 Specifications

Related product manuals