To Next Page

To Previous Page

5.41

9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual

REAR TRAILING ARM

Trailing Arm Removal / Installation

NOTE: Use new attaching nuts upon installation of

the rear trailing arm and bearing carrier.

1. Raise and support vehicle by main frame.

CAUTION

Serious injury may result if machine tips or falls. Be

sure machine is secure before beginning this service

procedure.

2. Remove the four wheel nuts and remove the rear

wheel.

3. Remove the cotter pin (Item 1) and loosen the rear

wheel hub castle nut (Item 2). Remove the nut, and

two cone washers (Item 3) from the rear wheel hub

assembly.

4. Remove the lower radius rod mounting bolt (Item 4),

nut and washer from the bearing carrier. Swing

radius rod down. Discard the nut.

5. Remove the two brake caliper mounting bolts (Item

5).

6. CAUTION: Do not hang the caliper by the brake line.

Use wire to hang caliper to prevent damage to the

brake line.

7. Remove the rear wheel hub and brake disk

assembly.

8. Remove the five remaining bolts (Item 6) that attach

the rear bearing carrier to trailing arm. Discard the

nuts.

BODY / STEERING / SUSPENSION

Polaris 2014 RZR XP 1000 Service Manual

Questions and Answers: