7.10
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
Rear Prop Shaft Removal
1. Remove the center console.
1. Cap 3. Torx Screw
2. Shifter
4. Push Rivet
2. Remove the two fasteners (Item 5) retaining the
support bearing cover (Item 6) to the frame.
3. While moving the prop shaft support bearing
assembly, slide the front prop shaft off the rear prop
shaft and remove it from the vehicle.
4. Once the front and rear prop shafts have been
separated, slide the rear prop shaft forward to
remove it from the transmission output shaft.
5. Remove the support bearing rubber bushing by
pulling it off the rear prop shaft.
6. Remove the rear prop shaft out of the left rear of the
vehicle.
Rear Prop Shaft Installation
1. Reverse the appropriate “Rear Prop Shaft Removal”
procedure to reinstall the rear prop shaft.
2. Lubricate the transmission output shaft splines with
Polaris All Purpose Grease.
3. Lubricate the front and rear prop shaft mid joint with
Polaris All Purpose Grease.
4. Slide the rear prop shaft forward from the left rear of
the machine just below the PVT cover. Install the rear
prop shaft on the transmission snorkel shaft.
5. Lubricate the support bushing with light oil to ease
installation and install the bushing on the rear prop
shaft bearing.
FINAL DRIVE
To Next Page
Loading...
Need help?
General
