Polaris 2014 RZR XP 1000 Service Manual

10.20
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
VEHICLE SPEED SENSOR
Speed Sensor Location
The speed sensor (Item 1) is located on the RH side of
the transmission, accessed through the rear RH wheel
well.
Speed Sensor Testing
1. Disconnect the 3 wire harness from the speed
sensor and remove the sensor from the
transmission.
2. Connect the wires from the Static Timing Light
Harness (2871745) to the sensor 3 pin connector
using the Hall Sensor Probe Harness ( 2460761).
3. Pass a screwdriver back and forth in front of the
sensor tip.
4. Be sure connections are good and 9V battery is in
good condition. If the light flashes, the sensor is
good.
IGNITION COIL
Operation Overview
The ignition coil (Item 1) is used to provide high voltage
to fire the spark plugs. When the ignition key is on, DC
voltage is present in the primary side of the ignition coil
windings. During engine rotation, an AC pulse is created
within the crankshaft position sensor for each passing
tooth on the flywheel’s encoder ring. The encoder ring
missing tooth creates an “interrupt” input signal,
corresponding to specific crankshaft position. This signal
serves as a reference for the control of ignition timing.
The ECU then calculates the time interval between the
consecutive pulses, and determines when to trigger the
voltage spike that induces the voltage from the primary to
the secondary coil windings to fire the spark plugs.
Ignition Coil / HT Lead Replacement
NOTE: The engine will misfire if the spark plug
wires are installed incorrectly. The spark plug wires
are marked with PTO and MAG from the factory and
should be installed to the corresponding cylinder
and ignition coil post.
1. Remove the seats and engine service panel to
access the ignition coil.
2. Disconnect the ignition coil harness and remove the
high tension leads from the coil.
3. Remove the fastener retaining the ignition coil and
remove it from the vehicle. If replacing the high
tension lead(s), remove the other end of the lead(s)
from the spark plug.
4. Install the new ignition coil and/or high tension lead
(s).
Ignition Coil Retaining Bolt: 75 in-lbs (8.5 Nm)
ELECTRICAL

Polaris 2014 RZR XP 1000 Specifications

General

Brand	Polaris
Model	2014 RZR XP 1000
Category	Utility Vehicle
Language	English