5.20
9924874 R02 - 2014 RZR XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
Hood and Front Body Work
Hood Removal
1. To remove the hood, turn both 1/4 turn latches (Item
1) to disengage the rear portion of the hood.
2. Lift rear of hood and slide forward to disengage the
front tabs and remove the hood from the vehicle.
Dash Removal
3. Remove the hood as previously described.
4. Remove the two T-40 Torx screws retaining the
Upper Dash cover between the front fenders (Item
2).
5. Disconnect the instrument cluster, AWD switch,
headlight switch, and ignition switch. Note their
location and wire routing. Remove the upper dash.
Lower Dash Removal
6. Back out the blue LED light from the lower dash.
7. Remove the two T-40 Torx screws retaining the dash
and the one T-40 retaining the back of the dash to
the bracket..
8. Remove the dash assembly from the vehicle.
NOTE: The lower dash is also held by clips. Pull
the dash straight out to disengage the clips..
Front Fender Flair Removal
9. Remove the six T40 Torx screws and remove fender
flairs (Item 1) from the dash assembly.
NOTE: Two of the screws will be longer than the
others. Note this for reassembly.
Front Body
10. Remove the hood, upper dash and fender flairs as
previously stated.
11. Remove the two T-40 Torx screw that were hidden
beneath the fender flair (one on the outside of the
fender and one on the inside).
12. Remove the front portion of the cab frame assembly.
Refer to appropriate “CAB FRAME - Assembly /
Removal” procedure for assembly torque
specifications.
13. Remove the front fender.
BODY / STEERING / SUSPENSION
To Next Page
Loading...
Need help?
General
