8.25
TRANSMISSION
8
9924096 - 2013 RANGER RZR XP 900 / RZR XP 4 900 Service Manual
© Copyright 2012 Polaris Sales Inc.
13. Lift up on the shift shaft rail (Q) and move the rail
assembly rearward to allow the shift fork pins to be
removed from the shift drum (R). Remove the shift
drum (R) from the transmission housing.
14. Remove the shift shaft rail (Q) and shift forks from the
transmission housing as an assembly.
15. Remove the rear output shaft assembly (S) by lifting
underneath the gear or by tapping the shaft from the
opposite side. If use of a pry bar is necessary, take
care not to pry on sealing surfaces of case.
16. Remove the idler gear shaft assembly (T) and gear
cluster assembly (U) from the transmission housing
by pulling both assemblies straight up.
17. Place the idler gear shaft assembly (T) and gear
cluster assembly (U) on a clean surface for inspection.
If disassembly is required, refer to “Gear Cluster
Disassembly”.
18. Slide engagement dog (X) off of shift fork guides.
19. Remove (2) screws and retaining plates, then lift shift
fork (Y) and torsion spring out of transmission
housing.
To Next Page
Loading...
Need help?
General
