Chapter 3: Configuring Your Library
Configuring Fibre Channel I/O Blades
206 Quantum Scalar i6000 User’s Guide
Adding an FC Host
1 Log on as an administrator.
2 Make sure that you are viewing the physical library. From the View
menu, click the name of the physical library.
3 Click Setup > Blades > Access > FC Host. The FC Host dialog box
appears.
4 Click Create. The Add Host Data dialog box appears.
5 Use the check boxes under Select Blades to select at least one blade
that the host will access.
6 Using the text boxes provided, provide the following required
information:
•In the Name text box, type a host device name.
•From the Type drop-down list, click the appropriate host type by
operating system.
•In the Port text box, type the host device port.
Note: The Port field can be used for any free-form text to help
better describe the connectivity. This field otherwise has no
configuration functionality.
•In the WWN text box, type the host device World Wide Name
(WWN).
7 Click OK.
Modifying an FC Host
1 With the host selected in the FC Host dialog box, click Modify. The
Host Configuration dialog box appears.
To Next Page
Loading...
Need help?
General