Renesas RL78 Series User Manual

RL78/F13, F14 CHAPTER 9 REAL-TIME CLOCK
R01UH0368EJ0210 Rev.2.10 678
Dec 10, 2015
9.4.2 Shifting to HALT/STOP mode after starting operation
Perform one of the following processing when shifting to HALT/STOP mode immediately after setting the RTCE bit to 1.
However, after setting the RTCE bit to 1, this processing is not required when shifting to HALT/STOP mode after INTRTC
interrupt has occurred.
 Shifting to HALT/STOP mode when at least two operating clocks (f
RTC) have elapsed after setting the RTCE bit to 1
(see Figure 9-20, Example 1).
 Checking by polling the RWST bit to become 1, after setting the RTCE bit to 1 and then setting the RWAIT bit to 1.
Afterward, setting the RWAIT bit to 0 and shifting to HALT/STOP mode after checking again by polling that the RWST
bit has become 0 (see Figure 9-20, Example 2).
Figure 9-22. Procedure for Shifting to HALT/STOP Mode After Setting RTCE bit to 1
Yes
RTCE = 1
RWAIT = 1
No
Yes
RWAIT = 0
No
RWST = 1 ?
RWST = 0 ?
RTCE = 1
HALT/STOP instruction
execution
Waiting at least for 2
f
RTC clocks
Sets to counter operation
start
Shifts to HALT/STOP
mode
Sets to counter operation
start
Sets to stop the SEC to YEAR
counters, reads the counter
value, write mode
Checks the counter wait status
Sets the counter operation
Shifts to HALT/STOP
mode
Example 1 Example 2
HALT/STOP instruction
execution

Renesas RL78 Series Specifications

General

Brand	Renesas
Model	RL78 Series
Category	Computer Hardware
Language	English