10 August, 2001 PROGRAM DOWNLOAD
4-71
Service
Tables
4.3 PROGRAM DOWNLOAD
1. Turn off the main power switch.
2. Remove the application cover [A].
3. Insert the IC card [B] containing the software you wish to download into the
card slot of the controller.
4. Turn on the main power.
5. Follow the instructions displayed on the LCD panel
6. Monitor the downloading status on the operation panel.
• While downloading is in progress, the LCD will display “Writing”. When
downloading has been completed, the panel will display “OK”.
• For operation panel software, the Start key lights red while downloading is in
progress, and then lights green again after downloading is completed.
$
CAUTION
Never switch off the power while downloading. Switching off the power while the
new software is being downloading will damage the boot files in the controller.
7. After confirming that downloading is completed, turn off the main power and
remove the IC card.
8. If more software needs to be downloaded, repeat steps 1 to 7.
9. Turn the main power on and confirm that the new software loads and that the
machine starts normally.
NOTE: If the download failed, an error message will appear on the panel. Then,
download the firmware again using the IC card as usual.
B022S999.WMF
[A]
[B]
To Next Page
Loading...
Need help?
General
