9. If a security warning dialog box appears, check the details, and then click [OK].
"Installed" appears under "Certificate Status" to show that a device certificate for the printer has
been installed.
10. Log out.
Creating the Device Certificate (Issued by a Certificate Authority)
Create the device certificate using Web Image Monitor. For details about the displayed items and
selectable items, see Web Image Monitor Help.
This section explains the use of a certificate issued by a certificate authority as the device certificate.
1. Log in as the network administrator from Web Image Monitor.
2. Point to [Device Management], and then click [Configuration].
3. Click [Device Certificate] under "Security".
4. Check the radio button next to the number of the certificate you want to create.
To use SSL/TLS, select [Certificate 1]. To use any other protocol, select the certificate number
desired.
5. Click [Request].
6. Make the necessary settings.
7. Click [OK].
The setting is changed.
8. Click [OK].
"Requesting" appears for "Certificate Status".
9. Log out.
10. Apply to the certificate authority for the device certificate.
The application procedure depends on the certificate authority. For details, contact the certificate
authority.
For the application, click Web Image Monitor Details icon and use the information that appears
in "Certificate Details".
• The issuing location may not be displayed if you request two certificates at the same time. When
you install a certificate, be sure to check the certificate destination and installation procedure.
•
Web Image Monitor can be used for creating the device certificate but not for requesting the
certificate to the certificate authority.
• Click [Cancel Request] to cancel the request for the device certificate.
5. Enhanced Network Security
118
To Next Page
Loading...
Need help?
General
Weight and Dimensions
