[Tools] Menu
678
Initial ValueSetting Item
CL4NX CL6NX
User
Reset
Factory
Reset
[LCD Brightness] 7 No Yes
[Show Total Count] Disabled Yes Yes
[Password]
[Password Enable] Disabled No Yes
[Install Security] Disabled No Yes
[NFC Security] None Yes Yes
[Start on AC] Disabled No Yes
[Tools] Menu
The initial value refers to the setting value of the printer when it was shipped from the factory. If you
reset the printer, the setting values of the printer will change back to the factory default values. The
table below shows the initial value of each setting item and type of reset that changes the value back
to the initial value.
• Normally, it is not necessary to perform the initialization. Doing so will remove all the
customer settings.
Initial ValueSetting Item
CL4NX CL6NX
User
Reset
Factory
Reset
[Test Print]
[Factory]
[Label Width] Large - -
[Pitch] 0 dot No No
[Offset] 0 dot No No
[Darkness Adjust] 50 No No
[Configure List]
[Label Width] Small - -
[Label Length]
203 dpi
800 dots
305 dpi
1200 dots
203 dpi
800 dots
305 dpi
1200 dots
Yes Yes