Cleaning
682
Maintenance
Cleaning the Printer
Cleaning
A dirty print head or platen roller not only affects the print quality but also causes errors. Use a
cleaning kit or cleaning sheet to clean the printer regularly.
• Do not touch the power button, connect or disconnect the power cord while your hands
are wet. Doing so could cause an electric shock.
• Disconnect the power cord from the AC outlet before you begin cleaning.
The print head and its surroundings are hot after printing. Wait until the printer cools
down.
• Touching the edge of the print head with your bare hand could cause injury.
• Be careful not to touch the cutter blade when cleaning the printer.
• Use a cleaning pen, cotton swab or cotton cloth from a cleaning kit to clean. Do not
clean with a hard object. Doing so could cause damage.
• Remove the media and ribbon before cleaning.
CAUTION for CL4NX only (if installed with linerless cutter kit)
• Open the print head if the printer is not used for printing for more than one day. Paper
jam might occur in the next printing if the print head is closed for a long period with
linerless label loaded.
• When loading linerless label, make sure that the front end of the media extends about
3 cm (1.18") out the media discharge outlet.
• The printer cleaning kit and cleaning sheet are optional. Contact your SATO reseller or
technical support center to purchase the options.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
