Description of the blocks
4.3 MMOprtn block
SIMOCODE pro PCS 7 Library V9.0
112 Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
Table 4- 21 Output messages
1
$$BlockComment$$ Group warning:
W
2
$$BlockComment$$ Group fault:
@5W%t#MMOprtn_TRP@
S
$$BlockComment$$ Control system fault
$$BlockComment$$ Warning I>
$$BlockComment$$ Warning I<
* W = Warning; S = AS, OS process control fault; A = Alarm
GenWarn and GenFlt block parameters
GenWarn is of the type DigvalE (DigvalE.Value: BOOL; DigvalE.ST: error number)
● GenWarn.Value = 1 if
the number indicating the cause of the warning is > 0.
● GenWarn.ST displays
the number indicating the cause of the warning.
GenFlt is of the type DigvalE (DigvalE.Value: BOOL; DigvalE.ST: error number)
●
GenFlt.Value = 1 if the number indicating the cause of the trip is > 0.
●
GenFlt.ST displays the number indicating the cause of the trip.
Table 4- 22 Output messages
$$BlockComment$$External message 1
$$BlockComment$$External message 2
$$BlockComment$$External message 3
$$BlockComment$$External message 4
$$BlockComment$$External message 5
$$BlockComment$$External message 6
$$BlockComment$$External message 7
$$BlockComment$$External message 8
* S = AS, OS process control fault
To Next Page
Loading...
Need help?
General
