Siemens SIMOCODE pro User Manual

Introduction
1.8 Parameterization softwares
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
35
Note
For Star
-Delta starter and Star-Delta reverse starter, Change over pause time configured in
device should be added along with Feedback/Execution time for Star
-Delta and
parameterized in ( < Dynamic monitoring time, MonTiDynamic = MonTiStatic).
1.8.3
Configuration with SIMATIC PDM
You can use the SIMATIC PDM software to configure the SIMOCODE pro C / S / V devices.
The devices are accessed via the PROFIBUS and PROFINET interface.
You can find information on configuration using the SIMATIC PDM software in the
documentation for SIMATIC PDM and SIMOCODE pro EDD.
Note
Transmission of modified device parameters is possible under the following conditions:
•
The device is
not
in the SIMOCODE pro "remote" mode.
•
No ON control command is active.
•
No motor current is flowing.
1.8.4
Device type selection in HW Config
You can select the device type in the HW Config as follows:
1. Start the SIMATIC Manager.
2. Open the "Settings" menu via "Options → SIMATIC PDM → Settings".
The dialog box opens.
3. Enable "Select type when device is inserted in HW Config".
4. Confirm by clicking OK and close the dialog box.
5. Close SIMATIC Manager and integrate EDD using the SIMATIC PDM "Device Integration
Manager".
Note
SIMOCODE pro V PN
PCS 7 V8.1 and above support integration of SIMOCODE
pro V PN devices using SIMATIC
PDM.

Siemens SIMOCODE pro Specifications

General

Brand	Siemens
Model	SIMOCODE pro
Category	Control Unit
Language	English