Siemens SIMOCODE pro User Manual

Description of the blocks
4.5 Block for statistical function MMStat
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
175
Statistical value
SIMOCODE
pro C
SIMOCODE
pro S
SIMOCODE
pro V
Parameter
Calculation module 1
–
–
X
CalMod1Out
Calculation module 2 – – X CalMod2Out
"X" = Statistical value is available, "–" = Statistical value is not available.
Additional statistical values for PROFINET devices
Table 4- 76 Additional statistical values for PROFINET devices
Statistical value
SIMOCODE pro V PROFINET
Parameter
Timer 5 actual value in seconds X Tmr5Act
Timer 6 actual value in seconds
X
Tmr6Act
Counter 5 - Actual value
X
Cnt5Act
Counter 6 - Actual value
X
Cnt6Act
Calculation module 3
X
CalMod3Out
Calculation module 4
X
CalMod4Out
Analog MultiplexerOutput
X
AnaMulOut
"X" = Statistical value is available, "–" = Statistical value is not available.
4.5.5
Message characteristics
MMStat signals the following errors at the block output:
● Rack fault (
RackF_Act)
● Module fault (
ModF_Act)
An error generates a group error
GrpErr in output parameter Err_Act.
These errors are not signaled as alarms as they are already part of the MMDiag block (both
on the DP master system and behind the Y-Link/ IE-PB-Link). The alarms are output using
the ALARM_8P function.
The messages can be enabled or disabled using the
MsgLock input.
The alarms are also suppressed if the block is in Out of service mode.
The alarms are suppressed on warm restart for the number of cycles set for power up in the
RunUpCyc parameter.

Siemens SIMOCODE pro Specifications

General

Brand	Siemens
Model	SIMOCODE pro
Category	Control Unit
Language	English