Description of the blocks
4.3 MMOprtn block
SIMOCODE pro PCS 7 Library V9.0
130 Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
The operator permissions for control commands are configured in the OS_Perm structured
parameters. These are transferred to WinCC via the
OS_PermOut and OS_PermLog parameters.
The block parameters are controlled via the FBs in CFC.
The activated parameter allows the operator to enter the desired commands.
The operator permissions control operation only in the faceplate.
Table 4- 39 MMOprtn operator permissions
0 0 0 1 = Operator is permitted to change to AUTO
1 1 1 1 = Operator is permitted to change to
MANUAL mode.
3 3 3 1 = Operator is permitted to change to "Out of
1 = Operator is permitted to activate Trip reset
15 15 15 1 = Operator is permitted to activate emer-
1 = Operator is permitted to activate test
17 17 17 1 = Operator is permitted to change the upper
18 18 18 1 = Operator is permitted to change the upper
19 19 19 1 = Operator is permitted to change the lower
20 20 20 1 = Operator is permitted to change the lower
1 = Operator is permitted to update data
To Next Page
Loading...
Need help?
General
