Description of the blocks
4.5 Block for statistical function MMStat
SIMOCODE pro PCS 7 Library V9.0
178 Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
The operator permissions for control commands are configured in the OS_Perm structured
parameters. These are transferred to WinCC via the
OS_PermOut and OS_PermLog parameters.
The operator parameters are controlled via the FBs in CFC.
The activated parameter allows the operator to enter the desired commands.
The operator permissions control operation only in the faceplate.
Table 4- 80 Operator permissions – MMStat
1 1 1 1 = Operator is permitted to change to "ON"
mode
3 3 3 1 = Operator is permitted to change to "Out of
21 21 21 1 = Operator is permitted to read data from the
OS_PermOut contains the permission information of all the parameters.
OS_PermLog contains the permission evaluated based on the current operating states.
To Next Page
Loading...
Need help?
General
