Introduction
1.6 Driver generator
SIMOCODE pro PCS 7 Library V9.0
20 Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
Driver blocks
Generating the driver blocks
Module driver generation for the signal blocks will insert driver blocks depending on the HW
Configuration.
The action includes the following steps:
● Determining and assigning the diagnostics address of the SIMOCODE pro device.
● Assigning the primary subnet address and module rack number for the SIMOCODE pro
device.
● Instantiating the OB_DIAG1 / OB_DIAG1_PN driver block for the SIMOCODE pro device.
● Instantiating the MMDiag driver block for reading the diagnostics information of the
SIMOCODE pro device.
● Setting the address of the device at the OB_DIAG1 / OB_DIAG1_PN, MMDiag and
MOD_SWT blocks.
● Creating interconnections between the OB_DIAG1 / OB_DIAG1_PN, MMDiag and
MOD_SWT blocks.
● Assigning the diagnostic address in the
DAddr parameter.
● Making interconnections between the MMOprtn, MMMeas, MMStat and MMLog blocks
and the MMDiag and MOD_SWT blocks.
Object lists and action lists
Hardware modules, among other things, are configured in HW Config.
The object lists and the action lists are used to generate the module drivers for these
hardware modules.
The object list contains a unique object identification number for each of these hardware
modules. Each object list is assigned to a particular hardware configuration.
The action list contains a list of actions. These actions must be executed for the object
identification numbers that appear in the object list. Examples of such actions include:
● Assigning the device address
● Interconnecting the input and output parameters of the driver block
The "Generate Module Driver" function generates the module drivers when the CFC is
compiled.
To Next Page
Loading...
Need help?
General
