Description of the blocks
4.3 MMOprtn block
SIMOCODE pro PCS 7 Library V9.0
Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
133
4.3.21 Diagnostics information
The diagnostics information is communicated to WinCC for display in the faceplates.
The following diagnostics information is available for SIMOCODE pro devices and for
SIMOCODE pro PROFINET devices:
● Status diagnostics, output via the parameter output
DiagSts
● Event diagnostics, output via the parameter output
Diag_Evt
● Warning diagnostics, output via the parameter output
Diag_Wrn
● Trip diagnostics, output via the parameter output
Diag_Trp
DiagSts – Status diagnostics
Table 4- 42 DiagSts – Status diagnostics for SIMOCODE pro devices
Bit Meaning
0 General fault
1 General warning
2 Device OK
3 Bus OK
4 PLC/PCS OK
5 Motor current flowing
6 On <<
7 On <
8 Off
9 On >
10 On >>
11 Start active
12 Interlocking time active
13 Change-over pause active
14 Positioner runs in open direction
15 Positioner runs in close direction
16 Feedback closed (FC)
17 Feedback opened (FO)
18 Torque closed (TC)
19 Torque opened (TO)
20 Test position feedback (TPF)
21 Operational protection off (OPO)
22 Remote mode
23 Emergency start executed
24 Cooling down period active
25 Pause time active
26 Device check active
27 Phase sequence 1-2-3
28 Phase sequence 3-2-1
29 DM-F enabling circuit closed
To Next Page
Loading...
Need help?
General
