Maintenance Station
5.1 Maintenance Station
SIMOCODE pro PCS 7 Library V9.0
232 Programming and Operating Manual, 06/2017, A5E40899442002A/RS-AA/001
Display Remark Message Caused by
Good - -
Message is locked - -
*) You can find detailed information on Signaling, Warning and Tripping described for
Dataset DS 92 – Device diagnostic in system manual of SIMOCODE pro PROFINET.
Messages
Messages for an incoming Signaling, Warning and Tripping event can be found using:
Tool Dialog/Alarm logging
For WinCC Alarm logging
or
at the faceplates diagnosis view of the device
For PDM-Menu Device > Faults/ Warnings/ Status Information - You will find
following tabs according to the event:
• Faults
• Warnings
• Status Information
For SIMOCODE ES-Menu Target System > Faults/ Warnings/ Status Information - You
will find following tabs according to the event:
• Faults
• Warnings
• Status Information
Further status information according to control and protection can be found:
Tool Dialog
For PDM-Menu Device > Control/ Status Information - Following group
boxes will display status information:
• Control
• Protection
For SIMOCODE ES-Menu Target System > Control/ Status Information - Following
group boxes will display status information:
• Control
• Protection
To Next Page
Loading...
Need help?
General
