Siemens SINUMERIK Commissioning Manual

Programming support
3.3 Activating a dialog from the NC program
Expanding the user interface
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
3-5
Select file F:\MMC2\COMIC.NSK in the "Startup" operating area using the softkeys "HMI"
→ "Editor" and attach the following text (after channels 1 and 2):
REM CHANNEL
TOPIC(machineswitch) COMIC_START(COMIC001MachineSwitch"...)
[compare the text for channels 1 and 2]
When the control is restarted (OFF/ON), the command channel is activated for the
corresponding channel.
Activation with HMI Advanced
Content of the COMIC.NSK file:
REM ----- TYPICAL COMIC START
REM CHANNEL 1
TOPIC(machineswitch) COMIC_START("COMIC001MachineSwitch
",/Channel/Configuration/mmcCmd[u1],
/Channel/Configuration/mmcCmdQuit[u1])
REM CHANNEL 2
TOPIC(machineswitch) COMIC_START("COMIC002MachineSwitch
",/Channel/Configuration/mmcCmd[u2],
/Channel/Configuration/mmcCmdQuit[u2])
3.3.1 Structure of "MMC" instruction
Programming
Syntax: MMC ("Operating area, command, Com file, dialog box name, user-data
definition file, graphics file, display time or acknowledgment variable, text
variables...", "Acknowledgment mode")
Parameters: Operating area Name of softkey used to call the configured user
dialogs.
Default: CYCLES displayed as "Cycles" on softkey
14 and accessible via the <ETC> key.
Command PICTURE_ON
PICTURE_OFF
FF
Select screen
Deselect screen
COM file Name of the dialog screen file (max. 8 characters,
in the user, manufacturer, or standard cycles
directory). The dialog display appearance is
defined here. The dialog screen is used to display
user variables and/or comment texts.
Dialog name The individual dialogs are selected via the dialog
names.

Siemens SINUMERIK Specifications

General

Brand	Siemens
Model	SINUMERIK
Category	Control Unit
Language	English