Siemens SINUMERIK Commissioning Manual

Commissioning a system
1.4 BIOS settings
PCU-Basesoftware (IM8)
Commissioning Manual, 03/2009, 6FC5397-1DP10-4BA0
27
1.4 BIOS settings
Overview
The BIOS of the PCU 50.3 is preset in such a way that no changes are required. The date
and time can be set under Windows or the HMI operator interface.
NOTICE
Your device configuration is preset for working with the software supplied with the unit. You
should only change the preset values if you have modified your device in any way, or if a
fault occurs when the unit is powered up.
Starting BIOS setup
1. Start the BIOS SETUP as follows:
Reset the device (warm or cold restart).
After the first boot up, the following message appears:
Press < F2 > to enter SETUP or <ESC> to show boot menu
2. Press the F2 key as long as the BIOS prompt appears on the screen.
The BIOS main menu opens:
3KRHQL[%,266HWXS8WLOLW\
,WHP6SHFLILF+HOS
6\VWHP7LPH
(6& ([LW
6\VWHP'DWH
6HOHFW,WHP
6HOHFW0HQX

6HOHFW
&KDQJH9DOXHV
6XE0HQX
)
)
6HWXS'HIDXOWV
6DYHDQG([LW
>@
(QWHU
+HOS
)
>@
,'(&KDQQHO0DVWHU >1RQH@
,'(&KDQQHO6ODYH >1RQH@
%RRW2SWLRQV
.H\ERDUG)HDWXUHV
+DUGZDUH2SWLRQV
6\VWHP0HPRU\  .%
([WHQGHG0HPRU\  .%
6$7$3RUW  >0%@
6$7$3RUW  >1RQH@
6$7$3RUW  >1RQH@
0HPRU\&DFKH
6$7$3RUW  >1RQH@
7DE!6KLIW7DE!RU
(QWHU!VHOHFWVILHOG
([DPSOH
+RXU0LQXWH6HFRQG
0RQWK'D\<HDU
>:ULWH%DFN@
6HFXULW\ %RRW 9HUVLRQ ([LW0DLQ $GYDQFHG
Figure 1-13 BIOS Main Menu (Example)

Siemens SINUMERIK Specifications

General

Brand	Siemens
Model	SINUMERIK
Category	Control Unit
Language	English