Programming help systems
1.4 ISO mode help
Online Help (HE1)
22 Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
Necessary files
• List of "ISO dialect 0" commands with the associated brief description
• TXT file for the jump to the PDF file
• PDF file which is to be displayed in the help
Program execution
The help checks the following machine data on startup:
• MD18800 MM_EXTERN_LANGUAGE
If the MD is activated, the controller switches over to the ISO dialect 0 mode.
If MD18800 = 1, MD20150 is evaluated.
• MD20150 GCODE_RESET_VALUES[n(active channel),47]
If MD20150 [47] = 2, the file entered in the INI file under "SiemensI" (ISO mode) is used
(otherwise the file under "Siemens" is used).
• MD10880 MM_EXTERN_CNC_LANGUAGE
MD10880 specifies whether the controller is to be designed for turning or milling in
ISO mode.
1.4.2 Extending ISO mode help
If additional descriptions are to be displayed in the ISO mode help, these must be inserted in
the form specified below:
• As a list of ISO mode commands with a brief description in the directory
"SiemensI=CST.DIR\" as file "IFIT_COM" or file "IFIM_COM"
(refer to Section "Extension of text files")
• As a help description (PDF file) and a TXT file of the same name in directory
"F:\USER\HLP"
Parameters of instruction definition
Technology/topic ID/extended help/instruction text/
descriptive text
"Extended help":
The following entries are possible in the "Extended help" parameter:
• Editor help
/"PDF file name", help ID, "page number"/
• Cycle help
/"PDF file name", help ID, "page number" (file name, help screen)/
To Next Page
Loading...
Need help?
General
