Configure hotkeys and PLC keys
4.2 Configuration
Expanding the user interface
4-4 Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
On delivery, the assignments for HK1 to HK6 are stored in KEYS.INI in the mmc2 directory
for the standard system:
Key Function
HK1 Position Machine operating area, last screen
HK2 Program Program operating area, last screen
HK3 Offset Parameters operating area, last screen
HK4 Prg. manager Main screen programming
HK5 Alarm Diagnosis operating area, alarm screen
HK6 Custom Default Custom operating area, last screen
(user interface configured by the user)
The assignment for ShopMill/ShopTurn applications is as follows:
Key Function
HK1 Position Machine operating area, last screen
HK2 Program Program editor, last status
HK3 Offset Offset area, last status
HK4 Prg. manager Program directory, last status
HK5 Alarm Diagnosis operating area, alarm screen
HK6 Custom Default Custom operating area, last screen
(user interface configured by the user)
4.2 4.2 Configuration
4.2.1 Configuration overview
Overview
Below is a schematic diagram illustrating the associations between configured OP hotkeys
and PLC keys and the "Expand user interface" configuration:
To Next Page
Loading...
Need help?
General
