Configuring the HMI system
2.2 Configuring a channel menu
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
55
Switching over channels
The following channel menu is displayed when the channel switchover key is pressed with
this configuration.
Select the channel menu using the channel switchover key from any operating area of the
HMI, as shown in the following example:
Figure 2-6 Example channel menu
Triggering channel switchover:
● Select the channel group (station) with the horizontal softkeys.
● The channels belonging to this group are now displayed on the vertical softkeys.
The control does not switch to the channel until the vertical softkey is pressed.
See also
NETNAMES.INI (Page 308)
Q
&+$11(/
To Next Page
Loading...
Need help?
General
