Note
S
tart view set automatically by wizard
The process value to display on device after power on is set automatically by the "Quick
commissioning wizard".
• When parameter "Operation" is set in the wizard, the value is written to parameter "Start
view".
• If a change is made to parameter "Start view" or parameter "PV selection" after running the
wizard, the last one set will apply.
• Options "Volume" and "Custom" are not visible in measurement view until congured. If one
of these uncongured options is selected in parameter "Start view", measurement view will
show the next visible process value.
9.2.7.2 Contrast (2.7.2)
Se
ts contrast level on local display.
Setting
• 0 %
•
10 %
• 20 %
• 30 %
• 40 %
• 50 %
• 60 %
• 70 %
• 80 %
• 90 %
• 100 %
Default 50 %
9.2.7.3 Display test (2.7.3)
Used t
o test device display.
9.3 Maintenance and diagnostics (3)
The following parameters relate to device maintenance and diagnostics.
Parameter assignment
9.3Maintenance and diagnostics (3)
SITRANS LR500 series with mA/HART
128 Operating Instructions, 03/2024, A5E51099898-AA
To Next Page
Loading...
Need help?
General
