Note
Eectivity of c
hange to user PIN setting
When the setting for parameter "User PIN" is changed, it will not take eect immediately. Once
setting is changed, a power cycle of the device or ten (10) minutes from last key press, must pass
before the change will take eect. (This delay applies only when a change is made to this
parameter on the local device, not via remote operation.)
9.5.6 Button lock (5.5)
Se
ts access to device buttons. When lock enabled, device operation is only possible via
engineering system.
To disable lock locally press
for 5 seconds, or use engineering system to disable remotely.
Setting Enabled Button lock is enabled
Disabled Button lock is disabled
Default Disabled
9.6 Language (6)
Se
ts the language for the local display.
Setting
• English
• Deutsch
• Français
• Italiano
• Español
• 汉语
Default Based on user congur
ation at initial startup.
Parameter assignment
9.6Language (6)
SITRANS LR500 series with mA/HART
148 Operating Instructions, 03/2024, A5E51099898-AA
To Next Page
Loading...
Need help?
General
