7.6.7 Testing the congur
ation
After conguring the device, it is recommended that you test the device to ensure that it
performs to your specications. This test can be run in simulation mode or by varying the actual
process value in the application. The latter is preferred, as it more accurately represents
operating conditions. However, if it is not possible to do a physical test, a simulation will ensure
that control programming is correct. For more details, see Simulation (Page89).
Commissioning
7.6Local commissioning
SITRANS LR500 series with mA/HART
84 Operating Instructions, 03/2024, A5E51099898-AA
To Next Page
Loading...
Need help?
General
