Siemens SITRANS LR580 - Installation Location Requirements

CAUTION
Hot surfaces resulting from hot process media
Risk of burns r
esulting from surface temperatures above 65°C (149°F).
• Take appropriate protective measures, for example contact protection.
• Make sure that protective measures do not cause the maximum permissible ambient
temperature to be exceeded. Refer to the information in Technical speci󹪝cations (Page 169).
CAUTION
External stresses and loads
Damag
e to device by severe external stresses and loads (e.g. thermal expansion or pipe
tension). Process media can be released.
• Prevent severe external stresses and loads from acting on the device.
NOTICE
Installation regulations
Ins
tallation shall only be performed by quali󹪝ed personnel and in accordance with local
governing regulations.
5.1.3 Installation location requirements
WARNING
Insu󹪟cient air suppl
y
The device may overheat if there is an insu󹪟cient supply of air.
• Install the device so that there is su󹪟cient air supply in the room.
• Observe the maximum permissible ambient temperature. Refer to the information in the
section Technical speci󹪝cations (Page169).
NOTICE
Aggressive atmospheres
Damag
e to device through penetration of aggressive vapors.
• Ensure that the device is suitable for the application.
Installing/mounting
5.1Basic safety notes
SITRANS LR500 series with mA/HART
Operating Instructions, 03/2024, A5E51099898-AA 37