3.10 Scan - [Advanced Settings] Screen
154
3.10.3 Threshold Sort (Classifying Halftones on the Document)
Use these steps to select whether to reproduce halftones on the document by using pseudo-halftoning or by
classifying halftones via binarization.
In general, halftones on documents are reproduced by using pseudo-halftoning method. You can select [On] under
[Threshold Sort] to choose classifying halftones via binarization.
Note
[Threshold Sort] cannot be selected when [Output Color] is set to [Color], [Grayscale], or [Halftone].
1.
Press [Threshold Sort].
2.
You can set the threshold for classifying halftones to
black or white.
3.10.4 Adjust Color Density (Adjusting Density Level for Individual Colors)
The following describes how to adjust density level of a color in order to enhance or suppress the color.
Note
TheColor Board & Page Memory for IIT is required to use this feature.
1.
Press [Adjust Color Density].
2.
Make adjustments for density level of individual colors.
Adjust
Select this check box to adjust the density level of individual
colors.
There are nine levels of density available for each of the
following colors: red, yellow, green, cyan, blue, magenta, and
black.
(Disabling a color)
Select the check box for a color to eliminate it from the
copied output.
To Next Page
Loading...
Need help?
General