9.1 System Settings Procedure
282
9.1 System Settings Procedure
To configure or change the system settings, you must enter the System Administration mode.
This section describes the basic procedures for system settings. Refer to the following setup procedures:
Step 1 Entering System Administration Mode...........................................................................................................................p. 282
Step 2 Selecting the Desired Item ..................................................................................................................................................p. 283
Step 3 Configuring a Feature............................................................................................................................................................p. 284
Step 4 Exiting System Administration Mode..............................................................................................................................p. 285
9.1.1 Step 1 Entering System Administration Mode
To enter the System Administration mode, enter the system administrator User ID. The password is also required
when [Password Entry from Control Panel] is set to [On] in [Authentication] under [Authentication/Security Settings].
We recommend that you change the system administrator user ID and password immediately after the machine has
been installed.
Refer
For information on how to change them, refer to "System Administrator Settings" (p. 330).
1.
Press the <Log In/Out> button on the control panel.
2.
Enter the user ID of the system administrator, by using
the numeric keypad or the keyboard displayed on the
screen, and press [Enter].
By factory default, the User ID is "11111".
The screen may differ depending on the settings
of the machine.
The <Log In/Out> button is lit when the machine
enters the System Administration mode.
Services Home
Copy (Not In Use) Review
Job Status
Machine Status
Dial Pause Speed Dial
ABC DEF
GHI JKL MNO
PQRS TU V WXYZ
Interrupt
Start
Stop
Clear All
Log In / Out
Energy Saver
<Log In / Out> button