Xerox Wide Format 6705 System User Manual

9
System Settings
9.5 Connectivity & Network Setup
312
TCP/IP - IP Mode
Allows you to select the TCP/IP operation mode.
The factory default is [IPv4 Mode].
IPv4 Mode
Select this to fix the internet protocol to be used to IPv4.
IPv6 Mode
Select this to fix the internet protocol to be used to IPv6.
Dual Stack
Select this to use both IPv4 and IPv6 as the internet protocol.
IPv4 - IP Address
Allows you to set the IP address.
Enter the address in the format of xxx.xxx.xxx.xxx, where xxx is a value between 0 and 255. Please note that a value
of 127 and a value between 224 and 255 cannot be used for the first xxx.
The factory default is [192.168.150.150].
IPv4 - Subnet Mask
Allows you to configure the subnet mask.
Enter the subnet mask in the format of xxx.xxx.xxx.xxx, where xxx is a value between 0 and 255.
The factory default is [255.255.255.0].
IPv4 - Gateway Address
Allows you to configure the Gateway address.
Enter the address in the format of xxx.xxx.xxx.xxx, where xxx is a value between 0 and 255. Please note that a value
of 127 and a value between 224 and 255 cannot be used for the first xxx.
The factory default is [0.0.0.0].
IPv6 Address Manual Configuration
Allows you to set the IP address manually.
To enter an IP address and Gateway address manually, select [Enabled].
The factory default is [Disabled].
Manually Configured IPv6 Address
Allows you to set the IP address.
Enter the IP address in the format of xxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx, where xxxx is a hexadecimal value.
Note

You can fill in this field only when [IPv6 Address Manual Configuration] is set to [Enabled].

Xerox Wide Format 6705 System Specifications

General

Brand	Xerox
Model	Wide Format 6705 System
Category	Printer
Language	English