48 Rockwell Automation Publication 2711P-UM006A-EN-P - November 2010
Chapter 4 Configuration Mode
Enter Configuration Mode on Startup
Follow these steps to automatically launch the FactoryTalk View ME Station
Configuration mode dialog on startup.
1. Choose Terminal Settings>Startup Options.
2. Press the On Startup button to select Go to Configuration Mode.
3. Press the Configuration Mode Options button.
4. Press the Load Current Application button to specify whether you want to
load the current application on startup.
5. Press the Replace RSLinx Communications button to specify whether to
use the communication configuration of the current application or that of
the terminal on startup.
• Select No to use the RSLinx configuration of the terminal.
• Select Yes to use the configuration of the application. The terminal
configuration is replaced with the application settings. Any changes to
device addresses or driver properties in RSLinx communication will be
lost.
6. Press OK to return to the previous dialog.
7. Press OK to return to Terminal Settings.
To Next Page
Loading...
Need help?
General
