Version 3.0.1 127 July 2010
MP-20x Telephone Adapter 11. VLAN and Bridge Settings
Parameter Description
Provide Host Name If
Not Specified by
Client
If the DHCP client does not have a host name, the device automatically
assigns one for him.
Figure 11-5: IP Address Distribution - DHCP Server
Table 11-3: DHCP Relay
Parameter Description
DHCP Relay Your device can act as a DHCP relay in case you would like to dynamically
assign IP addresses from a DHCP server other than your Telephone Adapter's
DHCP server. Note that when selecting this option you must also change the
device's WAN to work in routing mode. For detailed information, refer to
Section 10.28.2.
1. After selecting 'DHCP Relay' from the drop down list, a New IP Address link appears:
Figure 11-6: IP Address Distribution - DHCP Relay
2. Click the New IP Address link; the 'DHCP Relay Server Address' screen appears:
Figure 11-7: DHCP Relay Server Address
3. Specify the IP address of the DHCP server.
4. Click OK to save the settings.
To Next Page
Loading...
Need help?
General
