MP-20x Telephone Adapter 140 Document #: LTRT-50609
User's Manual
11.2.2 Settings Tab
Refer to 'Settings Tab' on page 125.
11.2.3 Bridge Tab
The Bridging tab allows you to specify the LAN and WAN devices that you would like to
join under the network bridge. Click the icon Edit on the 'VLAN' column to assign the
network connections to specific Virtual LANs. Select the check box 'STP' to enable the
Spanning Tree Protocol on the device. You should use this to ensure that there are no
loops in your network configuration, and apply these settings if your network consists of
multiple switches, or other bridges apart from those created by the Telephone Adapter.
Figure 11-29: Bridge Settings
To Next Page
Loading...
Need help?
General
