Version 3.0.1 89 July 2010
MP-20x Telephone Adapter 9. LAN Wireless Connection
9.2 Settings Tab
The Settings tab displays the connection's general parameters. It is recommended not to
change the default values unless you are familiar with the networking concepts they
represent. Since your MP-20x is configured to operate with the default values, no
parameter modification is necessary.
Figure 9-3: LAN Wireless 802.11g Access Point Properties - Settings Screen
Table 9-1: LAN Wireless Settings Tab Parameter Descriptions
Parameter Description
Schedule
You can configure scheduler rules to define time segments during which the
connection is active (refer to 'Scheduler Rules' on page 248). O
nce a
scheduler rule(s) is defined, the drop-down list displays available rules.
Network
Select whether the parameters you are configuring relate to a LAN/WAN/DMZ
connection.
Physical Address
The physical address of the network card used for your network. Some cards
allow you to change this address.
Clone My MAC
Address
Allows you to copy the current MAC address of your PC to the MAC address of
this device.
MTU
MTU is the Maximum Transmission Unit. It species the largest packet size
permitted for Internet transmission. By default, it is set to 'Automatic', whereby
the Telephone Adapter selects the best MTU for your Internet connection. In
case you change to manual, you can enter the largest packet size, you should
leave this value in the 1200 to 1500 range.
To Next Page
Loading...
Need help?
General
