Brother PE-Design 6.0 User Manual

84
Design Center Stage 4 (Sew Setting Stage)
Applying Sewing Attributes to Lines and
Regions
Region sewing
■ Applying sewing attributes to
regions
1. Click on the Tool Box.
→ The shape of the pointer changes to
, and the Sewing Attributes bar ap-
pears similar to the one shown below.
2. If necessary, change the color and sew type.
b Memo:
• You can change the color and sew type
either before or after applying sewing
attributes to the region. For more details
on changing these settings, refer to “Color”
on page 89 and “Sew type” on page 89.
• You can also use the settings in the
Sewing Attribute Setting dialog box to
define other attributes of the sew type. (For
more details, refer to “Specifying sewing
attributes” on page 89.) If you do not
change these settings at this time, the
current settings will be applied, however
you can modify them later.
3. Click the enclosed region where you want to
apply the sewing attributes.
→ “Marching lines” appear around the se-
lected region, and the color and sew type
selected on the Sewing Attributes bar are
applied to the region.
■ Checking the sewing attributes of
a region
1. Click on the Tool Box.
→ The shape of the pointer changes to
.
a Note:
If the attributes cannot be applied to a
region, go back to stage 3 (Figure Handle
stage) and make sure that region is closed.
Edit any broken lines with the Point Edit tool.
For details on editing the figure handle
image, refer to “Editing Points in Outlines” on
page 81.
PeDesignV6Eng.book Page 84 Thursday, July 8, 2004 11:59 AM

Brother PE-Design 6.0 Specifications

General

Brand	Brother
Model	PE-Design 6.0
Category	Software
Language	English