© Cesab 8 – 1 T Code(s): 841, 842, 843
Repair manual: Troubleshooting Model(s): S210, S212, S212S, S212L, S214, S214L, S220D
Publication Number: 7588857-040 Date: 2018-05-01 Applies from serial number: 6384351-
8. Troubleshooting
8.1 General
The troubleshooting section describes the error codes that are displayed
when the truck is partially or completely disabled. It also describes the cause
of the problem together with corrective remedies.
The electronic control system of the truck has built-in error code display and
logging. When an error occurs, the error code is shown on the display and
the error code LED flashes.
The first time an error code is displayed, try to restart the truck to check
whether the error condition remains.
If the error cannot be remedied through troubleshooting, contact the supplier
for more information.
Note:
The request "Restart the truck" means that the battery connector must be
disconnected before attempting to start the truck again.
Software compatibility
Ensure that the logic card ICH [A5], motor control ACT [T1] and battery
charger BCU [A30] have software from the same software package.
To ensure full functionality, the latest software package must be downloaded.
8.2 Towing a defective truck
The towed truck shall always have an operator who can steer and apply the
brake when towing using a tow-truck and tow-rope.
Always remove the load before towing or transporting the truck to the
specified repair site.
Tow or transport a defective truck as follows:
• Start the truck, move the tiller arm to the drive position and push the truck
by hand.
DANGER!
The truck can start to roll when the parking brake function is disabled.
Never leave the truck with the parking brake disconnected, chock the wheels
in a satisfactory manner.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
Need help?
General
