© Cesab 3 – 4 T Code(s): 841, 842, 843
Repair manual: General safety rules Model(s): S210, S212, S212S, S212L, S214, S214L, S220D
Publication Number: 7588857-040 Date: 2018-05-01 Applies from serial number: 6384351-
3.3 Safe lifting
All lifting must be carried out on a level, non-slip and stable surface. Asphalt
surfaces should be avoided if possible.
To prevent the truck moving while it is being lifted, it must not be lifted with
anyone on the platform or with the tiller arm in the lowered position.
If the drive wheel, which is braked, is being lifted the other wheels must be
chocked to stop the truck from moving.
Select the lifting point so that the lift is as light as possible, for example one
corner at a time. If the truck has marked lifting points on the lower part of the
chassis, these must be used to ensure balanced lifting.
Make sure the surface where the jack is placed is clean and free of oil and
grease.
Make sure your hands and the jack lever are free of grease and oil.
Only use the lever supplied with the jack. If the lever is too short, more
exertion than is necessary will be required. If the lever is too long, there is a
risk that the jack will be overloaded.
DANGER!
Risk of crushing since a poorly supported truck could fall down.
Never work under a truck that is not supported by trestles and secured by a
lifting device.
Support the truck:
• as close to the lifted part of the chassis as possible in order to reduce the
falling height if the truck should collapse
• so the truck cannot move.
Never support the jack on trestles to achieve a higher lift.
Never work under a raised truck without it being properly supported on
trestles.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
Need help?
General
