© Cesab 15 – 3 T Code(s): 841, 842, 843
Repair manual: Hydraulic system 6000 Model(s): S210, S212, S212S, S212L, S214, S214L, S220D
Publication Number: 7588857-040 Date: 2018-05-01 Applies from serial number: 6384351-
15.2.4 Storage
Hydraulic components must be handled and stored so that:
• no rusting can occur
• dust and dirt particles are shielded out
• no mechanical deformation can occur
15.2.5 Work procedures
When working on the hydraulic system, great cleanliness must be observed
so that no impurities can enter the system.
No work that generates particles may be carried out in the same workplace
or close to where work is being carried out on the hydraulic system.
The service technician must ensure that the components to be used are
carefully deburred and cleaned.
Couplings for pipe ends or other openings must never be removed until the
part is to be fitted to the receiving component.
Note:
All hydraulic components that have not been cleaned, e.g. pipe couplings and
nipples, must be blown clean before fitting.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
Need help?
General
