Cisco WS-C3560E-24PD-E User Manual

2-130
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
ip arp inspection limit
The rate of incoming ARP packets on EtherChannel ports equals the sum of the incoming rate of ARP
packets from all the channel members. Configure the rate limit for EtherChannel ports only after
examining the rate of incoming ARP packets on all the channel members.
Examples This example shows how to limit the rate of incoming ARP requests on a port to 25 pps and to set the
interface monitoring interval to 5 consecutive seconds:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# ip arp inspection limit rate 25 burst interval 5
You can verify your settings by entering the show ip arp inspection interfaces interface-id privileged
EXEC command.
Related Commands Command Description
show inventory
interfaces
Displays the trust state and the rate limit of ARP packets for the specified
interface or all interfaces.

Cisco WS-C3560E-24PD-E Specifications

General

Brand	Cisco
Model	WS-C3560E-24PD-E
Category	Switch
Language	English