B-60
Catalyst 3560 Switch Command Reference
78-16405-05
Appendix B Catalyst 3560 Switch Debug Commands
debug platform resource-manager
debug platform resource-manager
Use the debug platform resource-manager privileged EXEC command to enable debugging of the
resource manager software. Use the no form of this command to disable debugging.
debug platform resource-manager {all | dm | erd | errors | madmed | sd | stats | vld}
no debug platform resource-manager {all | dm | erd | errors | madmed | sd | stats | vld}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform resource-manager command is the same as the no debug platform
resource-manager command.
Related Commands
all Display all resource manager debug messages.
dm Display destination-map debug messages.
erd Display equal-cost-route descriptor-table debug messages.
errors Display error debug messages.
madmed Display the MAC address descriptor table and multi-expansion descriptor table
debug messages.
sd Display the station descriptor table debug messages.
stats Display statistics debug messages.
vld Display the VLAN-list descriptor debug messages.
Release Modification
12.1(19)EA1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
To Next Page
Loading...
Need help?
General