B-51
Catalyst 3560 Switch Command Reference
78-16405-05
Appendix B Catalyst 3560 Switch Debug Commands
debug platform messaging application
debug platform messaging application
Use the debug platform messaging application privileged EXEC command to enable debugging of
application messaging activity. Use the no form of this command to disable debugging.
debug platform messaging application {all | badpak | cleanup | events | memerr | messages |
usererr}
no debug platform messaging application {all | badpak | cleanup | events | memerr | messages
| usererr}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform messaging application command is the same as the no debug platform
messaging application command.
Related Commands
all Display all application-messaging debug messages.
badpak Display bad-packet debug messages.
cleanup Display clean-up debug messages.
events Display event debug messages.
memerr Display memory-error debug messages.
messages Display application-messaging debug messages.
usererr Display user-error debug messages.
Release Modification
12.1(19)EA1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, see the Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
To Next Page
Loading...
Need help?
General